3D PRINTED PLANE CHASSIS

I had already been constructing foam board RC planes for almost a yr when i purchased my first 3-d printer. I knew I desired to mix the two pursuits, but a search of existing plans speedy discovered a Goldilocks trouble: the printed components had been both insignificant sufficient that they did now not appreciably enhance the planes’ construct; or so numerous that they essentially converted a foam board plane right into a plastic one, VolgoPoint RC plane 2.

I realized that if I desired 3-D-revealed additives that made my scratch construct planes better with out detracting from the integrity (and forgiveness) of the foam board production, I need to layout them myself.

Over the path of a couple of prototypes and redesigns, I evolved a three-D-printed RC plane chassis. Like an car chassis, it affords a relaxed mount for vital load-bearing capabilities of the aircraft, which includes the dowels used to connect the wings to the fuselage, the motor mount, and landing equipment. The dowel securement prevents the dowel from tearing thru the foam. The motor mount offers a stable motor reference to a specific motor angle this is hard to breed always while scratch-building out of wooden and foam board. I additionally 3D revealed light-weight touchdown equipment (66g for a ski set), which attaches without delay to the wing dowels, thereby disposing of the want to reinforce the lowest of the aircraft and allowing simple removal or replacement with alternative tools.

most of the several models i have constructed incorporating my 3-d-printed fuselage support structure is a dual boom pusher. it is a attempted and proper RC plane layout with a few twists: specifically, three-D-printed components which include the chassis, growth mounts, and landing tools. The aircraft is built in two pieces with the receiver hooked up in the wing, therefore requiring handiest a unmarried servo twine connection (plus some rubber bands) to mate the wing and fuselage. i'm presently flying on Minnesota ice and snow with 3-d-printed skis; once spring comes, i will switch them out for wheels, VolgoPoint RC plane 2.